Wind Booster is a plug and play device develop to enhance driving pleasure by helping to provide necessary acceleration needed on drive-by-wire vehicles,Electronic Throttle Control (ETC).
Wind Booster electronic throttle accelerator used to solve electronic throttle (ETC) of the hysteresis problem. Wind Booster equipped vehicles will benefit brisk acceleration and fun to drive concept.
Advantages of Wind Booster:
Wind Booster can increase throttle sensitivity.
Wind Booster can help speed up.
Wind Booster can increase the security of the rate of overtaking.
Wind Booster is easy to install. (Approx.10 Min)
At low speed, the engine's response time will be shortened by half (if it is half-speed mode, the effect is slightly lower).
At Mid-acceleration, that is, up 4 files in 3 file continuous acceleration, the engine response delay is almost zero.
At high speed region will have greater difference.
The improvement of vehicles that can effectively enhance the effect of low-speed transmission and to prevent the vehicle before the channeling and therefore more secure.
Long-term use, a significant reduction in coke engines, engine Enduring new.
The design of the Wind Booster allows for its easy installation in all models, without the need to cut any wires or intervene in the automobile's electronics (it does not affect other systems such as electronic injection, ABS, etc.).
Its installation is extremely easy, requires no specific skills or tools – apart from a screwdriver – and takes only one minute. With the screwdriver in hand, you simply undo the safety connector clip and plug-in the device in the throttle's connector. The other end is plugged-in at the clamp that leads to the ECM. The device is "idiot proof" as one end is a male connector and the other female.
It can either be installed by you – using the easy step-by-step instructions below – or at any authorized dealer.
Installation Instructions:
Find the ECT connector under the steering wheel.
By undoing the safety clip with the screwdriver, unplug the connector and pull it in front of the pedal.
Plug-in the Sprint Booster and the cable back into its initial position.
Connect the ECM cable to the Wind Booster.
Makes sure all connections are firmly in place.
Manufacturer: N/A
SKU: WND-
